"Xbox One" was quickly broken up and turned out to be relatively easy to disassemble

In Europe and the United States, Xbox One released on November 22, 2013, summarizes the hardware disassembly / repair reportIFixitI got the first in New Zealand, decomposed quickly into disjointed pieces and released the report.

Xbox One Teardown - iFixit
http://www.ifixit.com/Teardown/Xbox+One+Teardown/19718

The Xbox One Teardown Review - YouTube


It has Xbox One, 8 core x86 processors, 8GB memory, 500GB storage, Blu-ray / DVD drive.


With a special controller like this, there are some design changes from the controller of the previous model Xbox 360. According to a representative of Microsoft, thisThe development cost of the controller is 100 million dollars(About 10.1 billion yen) or more.


Disassembly start of the main body immediately. I will look for the screw holding the housing but since I can not find anything, try removing the rubber slip at the four corners of the main body ... ...


But there is nothing.


Since screws etc are not found in particular, clip the plastic rod to the side exhaust port and remove the lattice part.


Paccari.


Now you can also remove the top of the body.


Then using the tool ......


Remove the Wi-Fi board.


This is Wi-Fi board removed, red frame part is Marvell made MIMO · 802.11ac · NFC · Bluetooth · Wireless display compatible chipAvastar 88 W 8897Also in the orange frame part is a Marvell made WLAN chip compatible with USB 2.0Avastar 88 W 8782.


And this is also removed.


This was a speaker.


Then remove the 64 mm screw ... ...


Open the pacari and the silver lid part.


And remove the HDD and the motherboard with the fan inside from the chassis whole.


Remove the SATA data connector about the motherboard ... ...


Remove Blu - ray / DVD drive.


Inside Blu - ray / DVD drive is like this.


Next, remove the HDD. Microsoft officially does not replace the hard disk drive, and its replacement is out of warranty so be careful. Although HDD seems to be able to install 2.5 inch SATA connection, it is unknown whether Xbox firmly recognizes it.


Built from the ground up is made by SamsungSpinpoint M8.


This is an RF module board.


The RF module board looks something like this, the integrated circuit written "9160F1MS03 1327 2317 B057" on the red frame part is ant.


Next, remove the fan.


OK if you remove the screw in the part marked with a cross on the back of the motherboard OK.


This makes it removable.


Separate the fan and heat sink. This work is very pleasant.


fan


The size of the heat sink is 112 square mm.


This is the motherboard with all parts removed. The red frame part is CPU, AMD's "Jaguar" core and Radeon GPU are used. There are 16 512 MB · DDR 3 SDRAM in orange frame part. 8 GB eMMC NAND Flash in the green frame part.


It makes me feel like this when I make them all apart. The decomposition difficulty level is 8 in 10 steps (the smaller the number, the higher the difficulty) and a fairly simple class. There are some necessary tools for disassembly, but it is not too difficult. However, it is necessary to keep in mind that it is difficult to replace the HDD, and that the replacement becomes out of warranty.