"Floyd Leg" review that allows you to turn any board into a desk in just 5 minutes

Moving or making a makeover is here! There are times when the table which is now in place says that it does not fit, but if you have a plate-like thing, it will make you transform into anything on the table "Floyd Leg"is. It is said that desks can be made without choosing materials, such as disused doors and abandoned wood chips, so I actually tried using them.

THE FLOYD LEG
http://www.thefloydleg.com/

This is "Floyd Leg" which arrived at the editorial department.


First let's try opening the Floyd Leg for a 16 inch (about 40 cm) coffee table.


Inside the four legs coated steel black.


It is about this size when you have it in hand.


And this is Floyd Leg for a table of 29.5 inches (about 75 cm).


Contents is like this.


The height was about the base of the foot of a woman with a height of 162 cm.


On the top of Floyd Leg, there is a part that sandwiches the board as follows.


Also, there were 4 round plates in the bag.


Taking out it looks like this.


By attaching the plate to the screw part of Floyd Leg, you can more firmly fix the leg to the board.


In addition, since any Floyd Leg is in the cover with the handle, it is possible to move it with the feeling as follows. A woman may feel a bit heavy when he has both, but it is not a weight that he can not hold.


So I will try to create a desk with the board that was in the editorial department.


Floyd Leg on the board perfectly closely ... ...


Tighten the screws firmly.


After installing the four legs ......


It was completed in no time. Creation time did not take as long as 5 minutes.


Then just use it like an ordinary row table.


I came to GIGAZINE warehouse by trying to utilize it further.


If you are looking for a plate with a nice feeling ... ...


was.


I will attach Floyd Leg to a bastard with a slightly stylish pattern.


The creation method is the same as above, but because there is some unevenness on the surface, in that case "Feld Leg and the felt put between the board OK is OK".


Like this.


After installing the four legs ......


Turn over to complete the desk.


I can not see the fashionable part of the hand.


Because it is a bran, various on the bottom are visible.


Floyd Leg is standing upright properly.


Looking somewhat from below it looks like this.


Placing the PC, the work space is completed in no time.


I will try this table next.


It is slightly thick, but ...


Completion of a low table with handmade feel without problems.


From another angle.


Looking from the side it is like this.


Because I am living a soft life that usually only touches a PC, I turned the skin off when I made a table three times. Let's do gloves if you make lots of tables.


You can check the intensity of the table you actually made from the following movie.

If it is a plate-like flat thing whatever you change to a table "Floyd Leg" - YouTube


The table of the low table does not move almost even if you put a lot of strength.


The load carrying weight is 75 pounds (about 34 kg) as a whole, but there was a sense of stability even when sitting on a trial.


On the other hand, a big desk saw a slight shake when putting force. Basically it is supposed to make a medium table from a small table, so it seems difficult to practice a large desk such as a dining table. It was a feeling that it could be used if it was a little baggage placement or working space that does not put heavy things too much.


So, it is not suitable for those who are planning to purchase a dining table etc. However, if you are considering purchasing a small to medium table, you can make a table of your size using a board Since it is possible, it is possible to create a table with space "born after changing the pattern" and "to decide where to place the table after purchase", it seems to be pretty useful. Depending on the material, it was also a big point that I could make a design table.


Floyd Leg about 40 cm for low table is $ 179 (about 18,000 yen), and Floyd Leg of 75 cm is 189 dollars (about 19,000 yen). When purchasing from Japan, the shipping fee is $ 65 (about 6600 yen) at the express delivery (6 to 10 days) of the US postal service and 200 dollars (about 20,000 yen) for the international courier service of the international courier company UPS, In this case it is possible to pursue luggage and insurance. Shipping is about one week.

Buy - THE FLOYD LEG
http://www.thefloydleg.com/buy/


In addition, the color was supposed to be chosen from white, black, red and blue.