I tried to carry the back pack "GOBAG" for travel that can store compressed packages

It appeared in Kickstarter in June 2015Ultimate travel backpack "GOBAG" which can store luggage in air by pulling out airSuccessfully commercialized by collecting funds, the real thing of the bag arrived at hand, so I actually touched it.

Pack Small. Think Big. | GOBAG
http://www.wearegobag.com/

◆ opening / exterior
Arrived at cardboard of design written as "OPEN HERE". IPhone 6s Plus placed in front.


GOBAG like appearance integrated with box emerges from inside.


I will remove the power. The size is height 50 cm, width 35 cm, depth 20 cm, capacity 35 liters.


The back side is like this, you need to install shoulder strap etc yourself later.


On the right side of the side (the face that comes to the right of the body when carrying it) is like this, the left side of the picture is the bottom side, the picture right is the top side. Fasteners are installed so as to go around the sides. In addition, handbags are attached so that they can be held even if lying sideways.


The other side. There are also handbags here, but the zipper is not round - triped, it ends to the bottom, it is not slightly symmetrical.


There was a "hole" on the top surface, and it was blocked with a cap.


The bottom surface draws a gentle curve with such a feeling.


First open the zipper and take out the fixtures inside.


Shoulder straps, waist belts, small cases, and the yellow ones on the right are the biggest features of this bag "Max Pack Bag".


In the small case there was a message card and instructions.


How to attach straps etc in the instructions ......


It is written how to use Max Pack · bag.


Inside the bag "Laptop harness" was fixed with hook and loop fasteners.


◆ Shoulder strap attachment
For use as a bag first attach a shoulder strap. There is a metal hook on the upper part of the strap, but pass it through the ring on the back side of the bag body including this.


If you pass it to the place of the hook and loop fastener, fasten this hook and loop fastener so that it folds back. As shown in the photo, the shoulder straps themselves are in a shape that warps.


I hook the hook that passed through the ring to the hole on the front side of the shoulder strap earlier.


After fixing the strap, the upper mounting is completed.


Since the hook is at the tip on the underside, thread it through a small snagging space on the bottom.


This completes installation on one side. Just install the other side in the same way.


When it is completed, it looks like this.


For the convenience of its mounting shape, the strap will be shaped like bouncing up.


◆ Waist Belt Mounting
It is OK even if you do not usually have it, but a belt is prepared for when you have heavy luggage.


It is OK if you hold the space in two places close to the bottom of the bag with a hook and loop fastener.


Installation completed.


With this kind of feeling, it holds my hips firmly.



◆ Compression strap
After completing the installation in this manner, you will notice that there are two hooks that are not fastened anywhere, two on the side of the bag.


This is a "compression strap". I hooked a hook in a hole that is located on the far side from the fastener ......


Pull a little and tighten.


This is a mechanism that you can compress the packed bag tightly and fix it.


When unnecessary, there is a hole in a position not crossing the fastener, so if you hook it here OK.


◆ Max · bag · bag
Subsequently, it is the biggest feature "max pack · bag".


The mouth part has a chuck like the one used in sweets bags and dish storage bags etc.


A pair of plastic buckles at both ends.


Also, at the bottom of the bag there are four zippered fasteners (hook-shaped) and not paired.


And holes and caps.


I will attach this to the bag.


First of all, remove the cap that was closing the hole on the top of the bag.


And, because there is a fastener on the side of the top side, I attach the fastener that was attached to the bottom of the bag here. This part is attached to the corner of the bag, you can not raise the fastener without pushing firmly and it was the hardest work in this preparatory work.


Fastener installation is completed. At the same time, hook the surface fastener (hook shape) on the bottom of the bag to the hook-and-loop fastener (loop shape) inside the bag.


Then, remove the cap attached to the hole of Max Pack · bag ... ...


Align with the hole in the bag. It is OK if it is roughly matched.


Align the removed cap with the hole from the outside and tighten.


The hole is connected to the inside of the bag.


Pack the packs you want to compress / compress, such as clothing, in the Max · bag · bag.


It became a size that it seemed to be hard to close the fastener.


Close the chuck first ... ...


Wrap the end of the bag so that the chuck is rolled inside.


And fasten the buckle that was attached to the tip of the chuck.


Looking from the side like this. After that, I will push this bag from the top. Since the cap tightened from the outside of the bag towards the hole of the max · pack · bag has a hole, it is constructed so that air can escape and the load can be compressed.


I actually tried to remove air. By the way, it is good to put the vacuum cleaner and bleed air.

Try removing air with GOBAG - YouTube


◆ Laptop harness
As I said, "Laptop Harness" that came out earlier is a fixture to fix a laptop PC.


When opened it is like this. Before using, pass the strap with hook and loop fastener through the hole on the yellow side.


Put the MacBook on the yellow side ... ...


I will wrap it like hanging the cover from the top.


When both sides are closed ......


I will put a strap at the end.


Fixed firmly with hook and loop fastener.


That's why we are guarded exactly.


Because this harness, a hook and loop fastener is also attached to the bottom ... ...


There is no worry about moving around in the bag.


I also entered the Let'snote CF-SX 3 equipped with 12.1-inch wide liquid crystal without problems. According to the official website seems to be no problem from 12 inches to 15 inches.



◆ Other functions
One thin pocket with waterproof zipper on the back side.


On the inside of the bag is one pocket that allows the inside to be seen with a mesh.


There is also a small space on the back of the waist. Although it can not open wide, I can not open things that I do not want to lose, I do not put in much out, but it is suitable for putting important things in.


The main fastener has a hole for attaching the lock.


Because there are not many pockets, it will increase the loading and unloading of luggage by opening the main room with nature, but due to the shape of the bag, it is difficult to "just open up a bit to take out." In such a case, putting the bag on its side ... ...


Accessible extensively to the back of the bag from here.


Small case fits perfectly even A6 size notes one size larger than the passport.


If you paste this case on the side surface fastener, you can take out what's inside while you need it.


Furthermore, when an adult male with a height of about 180 cm carries on it, it looks like this.


This is the state with the waist belt removed.


It seems as if he carries a bit black black box.


You can purchase this bag official website. When "Pick a currency" is set to "JPY", the price in Japanese yen will be displayed. Although the list price is 27,337 yen, at the time of article posting it can be purchased at 20,590 yen. Furthermore, shipping costs are required if it is not in the U.S. or the U.K.

GOBAG
http://www.wearegobag.com/products/gobag